Table of Contents
Advertisement
Safety Information
• This unit is a partial unit air conditioner, complying
with partial unit requirements of this International
Standard, and must only be connected to other
units that have been confirmed as complying to
corresponding partial unit requirements of this
International Standard.
• This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do
not play with the appliance.
Installing the unit
WARNING
IMPORTANT: When installing the unit, always remember
to connect first the refrigerant tubes, then the electrical
lines.
• Always disassemble the electric lines before the refrigerant
tubes.
• Upon receipt, inspect the product to verify that it has not been
damaged during transport. If the product appears damaged,
DO NOT INSTALL it and immediately report the damage to the
carrier or retailer (if the installer or the authorized technician
has collected the material from the retailer.)
• After completing the installation, always carry out a
functional test and provide the instructions on how to operate
the air conditioner to the user.
• Do not use the air conditioner in environments with hazardous
substances or close to equipment that release free flames to
avoid the occurrence of fires, explosions or injuries.
• Our units must be installed in compliance with the space
specifications presented in the installation manual in order
to ensure accessibility from both sides and allow repairs or
maintenance operations to be carried out.
The unit's components must be accessible and easy to
disassemble without endangering people and objects.
For this reason, where it is not observed as indicated into the
Installation Manual, the cost necessary to reach and repair the
unit (in safety, as required by current regulations in force) with
slings, trucks, scaffolding or any other means of elevation
won't be considered in-warranty and charged to end user.
4
English
• If any gas or impurities, except R-410A refrigerant, come into
the refrigerant pipe, serious problem may occur and it may
cause injury.
Use the supplied accessories, specified components and tools
for the installation.
– Do not use the pipe and the installation product used for
the R-22 refrigerant.
– Failure to use the specified components can cause
product fall down, water leakage, electrical shock, and
fire. (The pipe and flare components used for R-22
refrigerant must not be used)
– Excessive indoor humidity or clogged condensate drain
lines may cause water to drip from indoor units. Do not
install the indoor unit where dripping could result in
damage to property, such as above electronic equipment
or other sensitive instruments.
Power supply line, fuse or circuit
breaker
WARNING
• Always make sure that the power supply is compliant
with current safety standards. Always install the air
conditioner in compliance with current local safety
standards.
• Always verify that a suitable grounding connection is
available.
• Verify that the voltage and frequency of the power supply
comply with the specifications and that the installed
power is sufficient to ensure the operation of any other
domestic appliance connected to the same electric lines.
• Always verify that the cut-off and protection switches are
suitably dimensioned.
• Verify that the air conditioner is connected to the power
supply in accordance with the instructions provided in
the wiring diagram included in the manual.
• Always verify that electric connections (cable entry,
section of leads, protections...) are compliant with the
electric specifications and with the instructions provided
in the wiring scheme. Always verify that all connections
comply with the standards applicable to the installation
of air conditioners.
• Devices disconnected from the power supply should be
completely disconnected in the condition of overvoltage
category.
Advertisement
Table of Contents
