Step 14 Setting The Indoor Unit Addresses And The Installation Options - Samsung AC TN4PKC Series Instruction Manual

Installation Procedure
5 Wrap it with the insulation tape twice or more and position
your contraction tube in the middle of the insulation tape.
Method 1
Insulation tape
40 mm
6 Apply heat to the contraction tube to contract it.
Method 1
Contraction tube
7 After tube contraction work is completed, wrap it with
the insulation tape to finish.
Three or more layers of insulation are required.
Method 1
IInsulation tape
CAUTION
• Make sure that the connection parts are not exposed
to outside.
• Be sure to use insulation tape and a contraction tube
made of approved reinforced insulating materials
that have the same level of withstand voltage with
the power cable. (Comply with the local regulations on
extensions.)
WARNING
• In case of extending the electric wire, please DO NOT
use a round-shaped Pressing socket.
– Incomplete wire connections can cause electric
shock or a fire.
18
English
Method 2
Insulation tape
35 mm
Method 2
Contraction tube
Method 2
IInsulation tape
Step 14 Setting the indoor unit
addresses and the installation options
If the indoor unit requires a high level controller, you must
set the indoor unit address. But you must always set the
installation options, and set them by using the remote control.
You cannot set both of the indoor unit address and the
installation options in a batch: set both of them respectively.
Common steps for setting the addresses and options
AR-KH0** remote control (for 360 cassette only)
Entering the
mode for setting
the options
Temperature
button
Timer button
NOTE
• The remote control display may vary depending on the
model.
1 Enter the mode for setting the options:
a Remove the batteries from the remote control.
b While holding down the
(Timer) buttons simultaneously, insert the
batteries into the remote control.
c Make sure that you are entered to the mode for
setting the options:
Setting the
option values
Mode button
Wheel
(Temp) and