Table of Contents
Advertisement
CAUTION
• The indoor unit must be installed according to the
specified distances in order to permit accessibility from
each side, to guarantee correct operation, maintenance,
and repair of the unit.
The components of the indoor unit must be reachable and
removable under safe conditions for people and the unit.
• Do not hold the discharge while carrying the indoor unit
to avoid the possibility of breakage.
• You must hold the hanger plate on the corner and carry
the indoor unit.
Step 3 Optional: Insulating the body
of the indoor unit
If you install a cassette type indoor unit on the ceiling
over 80%, you must apply an extra 0.39 inch (10 mm) thick
polyethylene insulation or a similar type of insulation to the
body of the indoor unit.
Cut away the part where pipes are pulled out for the
insulating work.
Insulate the end of the pipe and some curved area by
using separate insulator.
NOTE
• A: Reference for the outer circumference of the unit
(When insulating the body of the indoor unit, use A as
the reference for its outer circumference.)
Indoor unit type and models
360 cassette type
37.28 x 37.28 x 11.06 inch
(947 x 947 x 281 mm)
360 cassette type
37.28 x 37.28 x 14.37 inch
(947 x 947 x 365 mm)
Step 4 Installing the indoor unit
When deciding on the location of the air conditioner the
following restrictions must be taken into account.
1 Determine the positions of the pipe and the drain hose
hole as shown in the pattern sheet, and drill the hole
with an inner diameter of 0.55 inch (14 mm).
NOTE
• Since the diagram is made of paper, it may shrink
or stretch slightly due to temperature or humidity.
For this reason, before drilling the holes, be sure
to maintain the correct dimensions between the
markings.
A
Dimensions
102.76 x 5.12 inch
AC018BN6DCH
(2610 x 130 mm)
AC024BN6DCH
AC030BN6DCH
102.76 x 8.46 inch
AC036BN6DCH
(2610 x 215 mm)
AC042BN6DCH
AC048BN6DCH
English
9
Advertisement
Table of Contents
