Samsung AC BN6DCH Series Installation Manual page 30

Hide thumbs Also See for AC BN6DCH Series:
Table of Contents

Advertisement

Installation Procedure
18 Press the
(Mode) button. Heat and Off appear on the remote control display.
19 Set the SEG23 and SEG24 values:
a Set the SEG23 value by rotating the Wheel
counterclockwise until the value you want to set appears
on the remote control display.
b Set the SEG24 value by rotating the Wheel clockwise
until the value you want to set appears on the remote
control display.
When you rotate the Wheel, values appear in the following order:
3 Check whether the option values that you have set are
correct by pressing the
[SEG2, SEG3]
[SEG4, SEG5]
[SEG11, SEG12]
[SEG14, SEG15]
[SEG21, SEG22]
[SEG23, SEG24]
4 Save the option values into the indoor unit:
Point the remote control to the remote control sensor
on the indoor unit and then press the
button on the remote control twice. Make sure that
this command is received by the indoor unit. When it is
successfully received, you can hear a short sound from
the indoor unit. If the command is not received, press
the
(Power) button again.
5 Check whether the air conditioner operates in
accordance with the option values you have set:
a Reset the indoor unit by disconnecting and then
reconnecting the power cable of the indoor unit or
by pressing the RESET button on the outdoor unit.
b Remove the batteries from the remote control,
insert them again, and then press the
button on the remote control.
30
English
Steps
(Mode) button repeatedly.
[SEG6, SEG8]
[SEG9, SEG10]
[SEG16, SEG17]
[SEG18, SEG20]
(Power)
(Power)
MR-EH00U and AR-EH**U remote controls
Entering the mode for
setting the options
High Temp button
Low Temp button
NOTE
• The remote control display and buttons may vary
depending on the model.
1 Enter the mode for setting the options:
a Remove the batteries from the remote control,
and then insert them again.
b While holding down the
(Low Temp) buttons simultaneously, insert the
batteries into the remote control.
Remote control display
SEG23
SEG24
Setting the option
values
Mode button
High Fan button
Low Fan button
(High Temp) and

Advertisement

Table of Contents
loading

Table of Contents