Table of Contents
Advertisement
Installation Procedure
6 Apply heat to the contraction tube to contract it.
Method 1
Contraction tube
7 After tube contraction work is completed, wrap it with
the insulation tape to finish.
Three or more layers of insulation are required.
Method 1
Insulation tape
CAUTION
Make sure that the connection parts are not exposed
to outside.
Be sure to use insulation tape and a contraction tube
made of approved reinforced insulating materials that
have the same level of withstand voltage with the power
cable. (Comply with the local regulations on extensions.)
WARNING
In case of extending the electric wire, please DO NOT
use a round-shaped Pressing socket.
– Incomplete wire connections can cause electric
shock or a fire.
20
English
Method 2
Contraction tube
Method 2
Insulation tape
Step 15 Setting the indoor unit
addresses and the installation options
You cannot set both of the indoor unit addresses and
the installation options in a batch: set both of them
respectively.
Common steps for setting the addresses and
options
AR-KH00E/AR-KH03E remote control (for 360 cassette
only)
Entering the
mode for setting
the options
Temperature
button
Timer button
NOTE
The remote control display may vary depending on the
model.
1 Enter the mode for setting the options:
a Remove the batteries from the remote control.
b While holding down the
(Timer) buttons simultaneously, insert the
batteries into the remote control.
c Make sure that you are entered to the mode for
setting the options:
Setting the
option values
Mode button
Wheel
(Temp) and
Advertisement
Table of Contents
