Set Up Instruction; Power On And Turn On / Off; Join Into Lora Network; Function Key - netvox R718H User Manual

Wireless pulse counter interface

Hide thumbs Also See for R718H:

Table of Contents

4.Set up Instruction

(1) Power on: Insert batteries: open the battery cover; insert two sections of 3.6V ER14505 AA

batteries and close the battery cover.

(2) Turn on: Press and hold function key for 3 seconds till the green indicator flashes once and

release.

(3) Turn off: Press and hold function key for 5 seconds till the green indicator flashes quickly and

release. The green indicator will flash 20 times to show that the device is turned off.

Note:

1. The interval between shutting down twice or power off/on is suggested to be about 10s to avoid

the interference of capacitor inductance and other energy storage components.

2. Do not press function key and insert batteries in the same time, otherwise, it will enter engineer

testing mode.

To join the device into LoRa network to communicate with LoRa gateway.

The network operation is as following:

(1) If the device had never joined any network, turn on the device; it will search an available LoRa

network to join. The green indicator will stay on for 5 seconds to show it joins into the network,

otherwise, the green indicator will be off.

(2) If R718H had been joined into a LoRa network, remove and insert the batteries; it will repeat

step (1).

(1) Press and hold function key for 5 seconds to reset to factory setting. After restoring to

factory setting successfully, the green indicator will flashes quickly 20 times.

Press function key to turn on the device which is in the network and the green indicator will flash

(2)

once and the device will send a data report.

Table of Contents