Table of Contents
Advertisement
2.3
Connection to the PC
2.3.1
Connecting cable
2.3.2
Software installation
762 IC Interface
Always switch off 762 IC Interface and PC before you connect the two
instruments with the 6.2134.100 Cable.
Connect the PC connection 10
rial COM ports at the PC using the 6.2134.100 Cable (9 pin/9 pin). If
only a 25-pin COM interface is available on the PC then the 6.2125.110
Adapter cable or a commercially available adapter must be used.
6.2134.100
762
Fig. 6: Connection of 762 IC Interface to PC
The PC program «IC Net 2.0» is required for the operation of the 762
IC Interface; this is contained on the 6.6034.003 CD included in the ac-
cessories. This program runs under Windows 95, Windows 98 and
Windows NT operating systems and is installed according to section
1.4.2 of the «IC Net» Instructions for Use.
2.3 Connection to the PC
10 at the 762 IC Interface to one of the se-
11
Advertisement
Table of Contents
Need help?
Do you have a question about the 762 IC Interface and is the answer not in the manual?