ETC ColorSource CYC Installation Manual page 5

ETC Installation Guide
ColorSource CYC v1.7/v3.1
Adjust the Tilt
When pipe-mounting the fixture, tilt the fixture so that the base of the
fixture is perpendicular to the cyclorama.
1. Loosen, but do not remove the yoke locking knobs.
2. Tilt the fixture so that the base of the fixture is perpendicular to the
cyclorama.
3. Tighten the yoke locking knobs.
Adjust the Spill Control
Adjust the angle of the spill
control as needed.
Set the DMX Address
1. Press any button to wake
the display. The display
shows the DMX address.
2. Use the Up and Down
buttons to select the
DMX address for the
fixture.
You can also use RDM for DMX addressing. See
page 11 .
Change the DMX Control Mode
You can set the DMX control mode for the fixture to one of four
available mode options.
1. Press any button to wake the display. The display shows the DMX
address.
2. Press and hold the Mode button for 3 seconds. The display shows
the current DMX control mode.
3. Press the Up button or Down button to change the DMX control
mode.
5ch
•
This is the default mode.
dir
•
lime, and strobe).
1ch
•
to 3200 K White).
rgb
•
4. Press the Mode button to confirm your selection.
The display will automatically return to the DMX address after 10
seconds of inactivity, and edits to the DMX control mode will not be
saved. This cancels unsaved changes.
ColorSource CYC
: 5-channel mode (intensity, red, green, blue, and strobe).
: Direct emitter control (intensity, red, green, blue, indigo,
: 1-channel mode controls the intensity of preset 1 (defaults
: RGB mode (red, green, and blue).
Spill
control
Page 5 of 12
RDM Values on
ETC