How To Use The Wireless Headset - NEC UNIVERGE SV9300 Series User Manual

ADJUSTING HEADSET RINGER
TONE VOLUME
You can adjust the ringer tone volume for a headset in an idle or
a busy state.
■The ringer tone can be sent to the headset by terminal
Menu settings. For the details, refer to
■A ringer tone volume can be adjusted only for a wired
headset connected to the terminal headset connector.
■A ringer tone volume in a busy state cannot be changed
when the ringer tone is set to be sent both the speaker and
the headset. For details, contact the system administrator.
To Adjust the Ringer Tone Volume in Idle
State
1.
Press the Headset key while in an idle state to
switch from headset mode to handset mode, and
the Headset key lamp turns off.
2.
Receives an incoming call.
3.
Press the UP/DOWN key while the terminal is
ringing.
For Ringer Tone Volume in Busy State
If other lines are accommodated in the telephone as a
subline, and when an incoming call is terminated to the
subline while a call in progress with headset, the ring tone
volume is lower than usual.
When you receive another call during a call with the headset,
the ringer tone volume for other lines in headset mode can
be set to the same level as the normal two-way call. For
details, contact the system administrator.
HOW TO USE THE WIRELESS
HEADSET
When using Wireless Headset (W710 (APD-80) or
WT100/Voyager Legend CS(APN-91)), you can answer a call,
conduct a conversation, or disconnect the call with hooking
operations. This section explains about the terminal operation
using Wireless Headset.
"MENU LIST".
To Answer a Call
1.
2.
74
HEADSET OPERATION
■The Headset button of Wireless Headset must be
programmed in advance. For the programming of Headset
button, contact the system administrator.
■For details on how to connect a telephone and Wireless
Headset, see the manual attached to the Wireless Headset.
Press the Call Control button of the Wireless
Headset while the terminal is ringing, and the
Headset button lights red. Depending on the
installation phase, you can answer the call with
※
hooking operations .
※ Hooking operations:Pressing Answer key or
Headset button.
Press Call Control button to end the call, and the
Headset button turns off.
When a party hangs up on the end of the call, the Wireless
Headset user may hear signal tones. However, it does not
affect the operation for the devices
.