Connecting Headset - NEC Univerge SV9300 Series User Manual

CONNECTING HEADSET

CONNECTING HEADSET WITH TERMINAL
According to the following procedure, Headset is connected to HEADSET Connector which is located bottom of
terminal.
The headsets which can be connected to the telephone are wired headset
and wireless headset with EHS (Electronic Hook Switch) cord.
For the headset that is supported, please contact the NEC's dealer or
NEC.
HOW TO CONNECT HEADSET
1. Plug the modular plug of headset into the HEADSET connector on the bottom of
terminal.
2. Fit the headset cord into the groove to be fixed.
(1)
Refer to the "TO MAKE A CALL USING HEADSET" on page
When using EHS (Electronic Hook Switch) wireless headset, there may
be a case that you will hear small tone signals.
This is a normal operation since this type of headset uses tone signals
for call controlling such as connection/disconnection etc.
(2)
(1) Terminal
(2) HEADSET connector
(3) Modular Plug
(4) Cord
(5) Groove
11
(3)
53.
INTRODUCTION
(4)
(5)