Installing A Smart Accessory; Collecting Data With The Instrument; Collecting Data With The Module - Thermo Scientific Nicolet Series User Manual

Installing a Smart Accessory

Collecting Data With the Instrument

Collecting Data With the Module

Thermo Scientific
To install a Smart Accessory™ in the sample compartment, lower the accessory into the sample
compartment and press gently downward until the accessory locks in place. Then rotate the
accessory lock (located on the top of the instrument at the back edge of the sample
compartment) so that it holds down the accessory.
Note
• If you want to remove a Smart Accessory, simply reverse the steps in this procedure.
When you are not using an accessory, store it in a dust-free environment like a cabinet
or box.
• For information about installing other kinds of accessories, see
Accessories.
For information about collecting data with your instrument, please see the getting started
manual that came with the instrument.
You must use Thermo Scientific™ OMNIC™ software to collect data. OMNIC can be started
by using the OMNIC shortcut on your system desktop. For additional information, please see
the OMNIC help (available through the Help menu in OMNIC) or the printed
documentation that came with the system microscope or spectrometer.
Operation
Installing a Smart Accessory
Installing Other
Nicolet iS20 User Guide 5