Replacing The Power Supply - Thermo Scientific Nicolet Series User Manual

Installing or Replacing Hardware

Replacing the Power Supply

Replacing the Power Supply
16 Nicolet iS20 User Guide
1. Remove any Smart Accessory, or if a Smart Accessory is not installed, remove the
baseplate. Disconnect any cables that are connected at the back of the sample
compartment.
2. If the accessory is purged through the windows in the side of the sample compartment,
install sidewall adapters.
3. Install the accessory.
Use the instructions that came with the accessory to make any adjustments or perform
any alignment procedures that are necessary.
Time needed:
5 minutes or less
Tools needed:
None
NOTICE Use only Thermo Scientific certified replacement parts. To order parts, contact
us.
WARNING
• To avoid a shock hazard, do not attempt to remove the cover of the power supply.
• Before you replace the power supply, always make sure you have turned off your
instrument and disconnected the power supply from the wall outlet or power strip.
1. Turn off the instrument.
2. Disconnect the old power supply.
Thermo Scientific