Installer Menu - ensto ECO16LCDJR Manual

9. INSTALLER MENU

Enter the installer menu: Select
Press the return button
Select the parameter you want to adjust with the joystick
Confirm selection by pressing the joystick
The current value is blinking. Now you can adjust the value with the joystick
Save by pressing the joystick
Restore the factory setting for the selected parameter by pressing the return button
Parameter
No Name Parameter description
10 LAnG Language
11 ⁰C Temperature unit
Temperature readout measured by intern sensor.
Note that the readouts represent raw data and must
Air
12
not be used as an indication of actual room tempera-
ture.
13 Flor Temperature readout measured by extern sensor.
Limitation scheme for the external sensor.
14 FL.Li
Minimum limitation temperature.
FL.Li
15
This parameter is only shown when one of the limita-
Lo
tion schemes is selected.
Maximum limitation temperature.
FL.LI
16
This parameter is only shown when one of the
Hi
limitation schemes is selected.
17 rEGU Control algorithm
bp
18 Proportional band for PI control [⁰C]
19 tCy Cycle time for PI control [minutes]
Minimum time for load switch on during the control
20 tOn
cycle [minutes].
Minimum time for load switch off during the control
21 tOFF
cycle [minutes]
28 rESET Factory settings
End
29 Exit the installer menu.
with the joystick.
for 10 seconds.
RAK126 / © Ensto 2019
Installer menu
Factory setting
EnGLISH
No limitation
18 ⁰C
28 ⁰C
Bp
PI control
2.0
10
Press the joystick
display is shut off
Alternative
setting
FrAnCAIS
⁰C ⁰F
Lo: Minimum limit
Hi: Maximum limit
Lo Hi: Combined
minimum and
maximum limit
From 5 ⁰C to
[FL.Li Hi – 0.5]
From [FL.Li Lo +
0.5] to 37 ⁰C
HYSt
On / Off control
Adjustable
0.1 ⁰C ... 12.7 ⁰C
Adjustable 1 ... 120
Adjustable
2
0 ... tCy / 120
Adjustable
2
0 ... tCy / 120
until the
Press the joystick
7