Adjustment Of The Current Outputs; Configurationof The On-Site Display; Factory Settings Of The On-Site Display For Level Measurements; Adjustment Of The On-Site Display - Endress+Hauser HART Levelflex FMP56 Operating Instructions Manual

Levelflex FMP56, FMP57
Endress+Hauser
10.6.2

Adjustment of the current outputs

The current outputs can be adjusted in the following menus:
Basic settings
• Setup ® Advanced Setup ® Current output 1 (® ä 113)
• Setup ® Advanced Setup ® Current output 2 (® ä 113)
Advanced settings
• Expert ® Output ® Curr. output1 (see document "Description of Device Parameters" GP01000F)
• Expert ® Output ® Curr. output 2 (see document "Description of Device Parameters"
GP01000F)
10.7

Configurationof the on-site display

10.7.1

Factory settings of the on-site display for level measurements

Parameter Factory setting for devices with 1 current
output
Format display 1 value, max. size
Value 1 display Levele linearized
Value 2 display Distance
Value 3 display Current output 1
Value 4 display None
10.7.2

Adjustment of the on-site display

The on-site display can be adjusted in the following menu:
Setup ® Advanced setup ® Display (® ä 117)
10.8

Protection of the settings against unauthorized changes

There are two ways to protect the settings against unauthorized changes:
• Via locking switch (hardware locking) (® ä 53)
• Via parameter settings (software locking) (® ä 54)
Factory setting for devices with 2 current
outputs
1 value, max. size
Levele linearized
Distance
Current output 1
Current output 21
Commissioning
67