Grundfos Conex DIA-2 Installation And Operating Instructions Manual page 40

11.6.3 Controller control fields on the display
1. Press [Esc] once or twice to switch to the display
"measured value".
See sections 11.2 Display elements during initial
commissioning and 11.2.1 Display
chlorine
0.43
mg/l
5.20 pH
22 °C
Fig. 32 Chlorine measurement with pH and temperature compensation
• The control fields for relays 1 and 2 appear as
follows for configured limit monitors / two-position
controllers:
Unfilled field for relay off:
1
Filled field (displayed inversely) for relay on:
1
• The control field for the continuous controller is
empty, partially filled or completely filled
depending on the set dosing rate - and when
configured accordingly - and the filling of the bar
always refers to 100 % of dosing rate.
Example:
0 %:
50 %:
100 %:
40
modes.
controller control fields
1
continuous controller output
1
relay 1 or 2
c
c
control fields for pH or temperature
pH-meas. value,
temp. meas. value
"c" = compensation on