Grundfos Conex DIA-2 Installation And Operating Instructions Manual page 39

11.6.2 Setting the controller parameters
1. Select a controller in the "setup" menu and
configure it.
See section 11.5.5 Controller parameters
2. Select the line "controller" in "main menu" using
the [Up] and [Down] buttons, and press [OK] to
switch to the "controller" menu.
See section 11.4 Main menu.
The "controller" option in "main menu" is
Note
only available if a controller has been
selected in the "setup" menu!
setpoint contrl
limit contact
limit
hysteresis
stop
* only with PID
** only with PI, PID
Fig. 31 Settings for setpoint controllers
1/2.
main menu
controller
parameter 1/2
settings in the setup menu
setpoint contrl
interpulse ctrl.
setpoint
prop.band xp
reset time TN**
deriv.action TV*
int.pulse period
Min.ON time
constant load
max.dosing flow
adaptation**
stop
The options available in the "controller" submenu
(main menu) correspond to the configuration made in
the "setup" menu.
1. Use the [Up] and [Down] buttons to change
internal setpoints within the selected measuring
range.
See section 8.4 Measuring
2. Select the displayed controller parameters using
the [Up] and [Down] buttons, press [OK] to switch
to the desired submenu, and use the [Up] and
[Down] buttons to adjust the setpoints as needed
within the permitted ranges.
See section 8.3 Electronic data and
setpoint contrl
pulse freqcontrl.
setpoint
prop.band xp
reset time TN**
deriv.action TV*
max.frequency
constant load
max.dosing flow
adaptation**
stop
ranges.
functions.
setpoint contrl
cont.controller
setpoint
prop.band xp
reset time TN**
deriv.action TV*
constant load
max.dosing flow
adaptation**
stop
39