Display Elements During Initial Commissioning - Grundfos Conex DIA-2 Installation And Operating Instructions Manual

11.2 Display elements during initial
commissioning
When connected to the power supply on the device's
initial commissioning and following the start-up
indication, the display shows the "Sprache/language"
menu.
Language/Langue...
Deutsch
English
Français
Nederlands
• The word "language" in the header is displayed in
all available languages successively at intervals
of approximately one second.
®
Start the Conex DIA-2 by selecting the desired
operating language:
1. Select the desired language using the [Up] and
[Down] buttons.
– The selected language is displayed inversely
(white letters on black background).
2. Press [OK] to confirm.
The selected language is stored and will
remain the operating language when the
device is rebooted. If necessary, the
Note
operating language can be changed in the
"language" submenu in the "setup" menu.
See section 11.5 Setup.
The translations for the words "setup" and "language"
into the currently available languages are:
Deutsch
Hauptmenü Grundeinstellung
English
main menu setup
Français
Menu principal Paramétrage
Nederlands
hoofdmenu basisinstelling
Español
Menu principal Ajuste básico
Italiano
Menu principale programm. fond.
Português
Menu principal Posição inicial
Pусский
главное меню станд. настройка
Polski
manu główne ustawienia
chlorine
0.43 mg/l
• After selecting and confirming the operating
language by pressing [OK] during initial
commissioning, the display shows "chlorine" as
the value to be measured.
– On subsequent start-ups, the display will show
the measured value selected the previous time.
chlorine
• On upward or downward violation of the selected
measuring range, the display will show the upper
or lower limit and flash.
See sections
11.5.4 Setting the measuring ranges for chlorine,
chlorine dioxide, ozone, peroxide and
Sprache
language
Langue
taal
Idioma
lingua
Língua
язык
język
0.43
mg / l
5.20 pH
22 °C
8.4 Measuring ranges
c
c
and
pH.
27