Table of Contents
Advertisement
MT HORIZONTAL MIXER WAGON
Besides checking the hydraulic oil level, other maintenance operations should be done:
a) Visual, periodic review of possible oil leaks.
b) Visual, periodic review of the hydraulic hoses, checking for possible points of wear.
When a hydraulic hose is broken, or oil leaks are detected, the mixer must be automatically stopped, and
must be checked by an specialist, as if the loss of hydraulic oil is , since if the level of the hydraulic oil tank is
lowered excessively, overheating may occur, which would cause irreversible damage to the hydraulic
components.
Any intervention on the hydraulic circuit must be carried out solely and exclusively by
specialized personnel, due to the risk involved in handling these elements, due to working
In case of breakage of hoses, these may only be replaced by specialized personnel.
The replacement of hoses without washing them can cause major breakdowns of the
4.11. ELECTRIC SYSTEM
Lighting systems (optional)
The mixer's rear and front reflectors should always be kept clean and in good condition.
The lighting and signaling system for road traffic must always be kept in perfect condition, to ensure that the
mixer is seen by the users of the roads through which it circulates.
The different elements in the lighting and signals system should be periodically checked using the controls
found in the inside of the tractor cab. The help of another person is recommended.
any bulb as well as any other elements that have been damaged while the machine has being used.
Scale
In order to be sure the scale works correctly, keep the following recommendations in mind:
1. Avoid knocks to the screen and the cells. Rough hits to the wheels when travelling on roads in poor
conditions can cause the weight cells to deteriorate, causing a defective weight reading.
2. Do not allow water to enter the inside of the screen of the scale or the junction box.
3. Periodically check and assure that the weight indicated by the scale is correct.
4. When any error is observed in the weight, the following should be checked:
a)
the cables make good contact, and they have no cuts that may provoke poor connection.
b)
That the bolts and the load cells clamps are not broken or bent, causing contact between the tub
and the chassis.
c)
That the weight cells have not suffered deformations due to rough hits.
5. Do not manipulate the junction box or the weight cells.
Any work on the weighing system should be done exclusively by specialized
personnel.
at high pressures.
hydraulic components.
USER'S MANUAL
Immediately replace
Advertisement
Table of Contents
