Table of Contents
Advertisement
MT HORIZONTAL MIXER WAGONS
2.3.
FRONT JACK
The mixer is equipped with a front jack, that can be mechanical or hydraulic, that will help you to hook up
the mixer to the tractor, as well will facilitate the parking of the mixer.
In the case of the hydraulic front jack, it comes equipped with a control lever A control lever (P) attached to
the side of the tub is used for operating the hydraulic jack.
M
Figure 2.3 Mechanical Trailer Jack.
Hitching the mixer:
1.
Back the tractor up to the mixer hitch.
2.
Adjust the height of the mixer drawbar at the point which hitches to the tractor using the handle
(M) in the case of the mechanical jack. If the mixer has a hydraulic jack, situate it in (Ap)
position and work it using the lever (P) in order to lift the drawbar. Slowly release the knob (V)
to lower it if needed.
3.
Hook up using a hitch pin that has the appropriate diameter respecting.
4.
Check that the mixer has been hitched correctly and completely raise the jack with the handle
(M). If using a hydraulic trailer jack, it is necessary to totally loosen the knob (V) so that the jack
will lift completely. Then, lower the jack, if this is an option, to release the lock bolts (F).
5.
If the mixer has the hydraulic jack, tighten knob (V) again, take out the lever, and place it in its
support.
V
Figure 2.4 Hydraulic Trailer Jack
Ap
Tl
Tv
Ap: Lever fitting (P)
Tl: Oil fill plug
Tv: Oil drain plug
Figure 2.5 Hydraulic Trailer Jack View
USER'S MANUAL
P
27
Advertisement
Table of Contents
