Advertisement
25.9.
Seating the lower bead
Place the wheel rim on the tire changer, position it with the sensor at 9 o'clock and
lock the rim. Position the tire on the rim and move the head to its working position.
Place the bead over the rear end of the head and pry the tire into the wheel well. The
sensor should be safely positioned halfway between the seating area on the head and
the wheel rim. Slowly rotate the wheel until seating the bead.
25.10. Seating the external bead
Place the sensor nearly at 9 o'clock with respect to head. These tires normally have
stiff sidewalls and it might be convenient to use pressure rollers (positioned as shown
in the picture) to pry the bead under the wheel well edge.Slowly rotate the wheel until
seating the bead.
English
Follow the instructions provided by the manufacturers of tyre changer,
tire and sensor. Inflating the tire involves potential risks to operator
safety; follow the instructions of tire and sensor manufacturers.
Check sensor for proper operation before refitting the wheel to avoid
removing the wheel again in the event the sensor needs to be
replaced.
When you have installed all four wheels, check that sensors are in
the correct positions using the "Location Test" function
Advertisement
