For Your Safety: PLEASE READ THIS MANUAL IN ITS ENTIRETY BEFORE ATTEMPTING INSTALLATION OR OPERATION! Attempting to operate the Mini ID without fully understanding its features and functions may result in unsafe conditions. Always use protective eye wear and observe proper safety procedures when working with pressurized gases. Identifier Warnings Sample Filter Warning: The Mini ID contains a unique filter designed to significantly reduce the probability of oil contamination.
Page 3
• NEVER obstruct the air intake, sample exhaust or case vent ports of the instrument during use. • WARNING – This Identifier must not be operated in flammable atmospheres. • CAUTION – Should be operated by certified personnel. • Avoid breathing A/C refrigerant and lubricant vapor or mist. Exposure may irritate eyes, nose and throat.
Page 4
This work is protected under International Code and is the sole property of Magneti Marelli Aftermarket Sp. Z o.o. No part of this document may be copied or otherwise reproduced, or stored in any electronic information retrieval system, except as specifically permitted under International copyright law, without the prior written consent of Magneti Marelli Aftermarket Sp.
Page 5
The Mini ID is an economical instrument designed to provide a “PASS” or “FAIL” indication for R134a Purity. The product will also indicate if an excess amount of non-condensable gas (air) is present in the system. Excess “air” will cause poor cooling performance and can be easily corrected by simply recovering the refrigerant, evacuating the system and recharging the vehicle.
NSTRUCTIONS WARNING: Be sure to turn off the vehicle and let it rest for 3 minutes. Connect the power cable to the power port located on the bottom of the instrument. Connect the power clips to the 12 VDC battery source. Be sure to observe the correct polarity. The lights will sequence, press “NEXT”...
5. Reconnect the unit and re-test. If these steps fail to restore the unit to good working order, contact: Magneti Marelli Aftermarket Spółka z.o.o. Plac Pod Lipami 5, 40-476 Katowice Tel.: + 48 (032) 6036107, Faks: + 48 (032) 603-61-08 e-mail: checkstar@magnetimarelli.com...
Page 10
The terms of these warranty provisions shall apply to all products sold by Magneti Marelli Aftermarket Sp. Z o.o., except filters which are considered “consumab le items,” and as such are not covered by the terms of these warranties. No waiver, alteration or modification of the terms of these provisions shall be valid unless in writing and signed by an ex- ecutive officer of Magneti Marelli Aftermarket Sp.
Page 11
MAGNETI MARELLI AFTERMARKET SP. Z O.O. warrants, subject to the terms listed below, that the goods will be free from defects in design, materials, and workmanship for a period of (1) one year from the date that the goods are shipped to the buyer.