Advertisement
The password is associated with the serial number of your tester and
the database release you have enabled.
How to position the equipment during sensor test or universal sensor
19.
programming
The equipment incorporates a low-frequency antenna to transmit sensor data. An
arrow on the top panel of the TPMS CONNECT EVO shows where the tip of the antenna
is located. In order to properly energize the valve, the equipment must be aligned with
valve body as shown in the figure below. Anyway, the equipment must be placed over
the tire and tilted towards valve body.
This set-up ensures the ideal condition for low-frequency data transmission to the
sensor installed inside the tire. Other set-ups, like that shown in the next figure, could
lead to noise between equipment and valve. This prevents communication between the
two and makes accurate sensor diagnosis impossible.
If after updating the tester you select a vehicle and get
not available - Contact Service", it means you have used a password
for an older release than that of the current database on the tester.
Contact your supplier to obtain the latest release password
Correct position
"Vehicle
Advertisement
