Advertisement
check the tyre pressure read by the control unit and read other design
-
parameters;
relearn/reprogram the sensor ID code in case of replacement (if needed);
-
carry out several adjustments when foreseen (summer/winter tyres, alarm
-
thresholds, function enabling/disabling).
The TPMS CONNECT EVO PLUS accessory is especially suitable for sensor replacement
procedures since it reads the ID code of the new sensor through Radio Frequencies even
with fitted tyre, and writes this code in the control unit thus avoiding the user to
manually enter it.
During all operations the vehicle dashboard must always be on (key
ON but engine OFF). Otherwise the instrument will not be able to
communicate with the vehicle on-board control unit and the relevant
error will be triggered. Pay attention to those vehicles that switch off
the dashboard after some time to save the battery.
Connect the diagnosis socket when prompted by the instrument.
We recommend connecting it completely to avoid fake contacts and
communication problems.
When you are prompted to connect the EOBD cable the display will
show the position of the diagnosis socket on the vehicle. Warning: in
certain cases to reach the diagnosis socket it may be necessary to
open/remove the door.
Vehicle models differ one from the other so for this reason operations available on one
vehicle may be completely different from those available on other models.
Advertisement
