Advertisement
7
8
Step 7: In some cases, the sensor will transmit data if it senses a pressure
variation of a least 0.2 bar in the tire. When the tester shows a message
reading Deflate tire, it means that you need to reduce induce a pressure
variation in order to enable valve data transmission.
Step 7 : If the tester receives data in the wrong format but signal is the
correct frequency, message "f=433MHz Sensor not recognized" is
displayed. If the tester did not receive the frequency signal either,
message "No signal received".
If the tester receives the correct data from the
valve,
it
will
temperature, battery state and ID (identification
code). Press Enter to go to the next menu.
This menu offers the following options:
ESC to go back to tester main menu.
to repeat the test without going back
to main menu in the event the tester was
unable to communicate with the sensor.
lets you save the test to tester
memory.
beep
and
display
pressure,
Advertisement
