Maintenance And Troubleshooting - NordicTrack FUSION CST STUDIO User Manual

MAINTENANCE AND TROUBLESHOOTING

HOW TO MAINTAIN THE STRENGTH SYSTEM
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the strength system is used.
Replace any worn parts immediately. Use only manu-
facturer-supplied parts.
To clean the strength system, use a damp cloth and
a small amount of mild detergent. IMPORTANT: To
avoid damage to the console, keep liquids away
from the console and keep the console out of
direct sunlight.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power adapter is fully plugged in.
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, first unplug the power
adapter, and then follow the steps below.
See the drawing below. Grip the Tower Top Cover (2)
firmly and remove it from the strength system.
With the help of a second person, grip the sides of the
Mirror (59), and then lift the Mirror upward and off the
strength system. Set the Mirror aside in a secure place;
be careful to avoid scratching or damaging the
Mirror.
59
Locate the Reed Switch (25). Slightly loosen the
indicated screw (A).
Then, rotate the Resistance Disc (6) until a Magnet
(119) is aligned with the Reed Switch (25). Slide the
Reed Switch slightly toward or away from the Magnet.
Then, retighten the screw (A).
Plug in the power adapter and rotate the Resistance
Disc (6) for a moment. Repeat these actions until the
console displays correct feedback.
When the reed switch is correctly adjusted, unplug
the power adapter and reattach the parts that you
removed. Then, plug in the power adapter.
18
2
A
119
6
25