NordicTrack FUSION CST STUDIO User Manual page 19

HOW TO TIGHTEN THE ROPES
The ropes may stretch slightly over time. If there is
slack in the ropes before resistance is felt, the ropes
should be tightened. To tighten the ropes, first unplug
the power adapter, and then follow the steps below.
See the drawing below. Grip the Tower Top Cover (2)
firmly and remove it from the strength system.
With the help of a second person, grip the sides of the
Mirror (59), and then lift the Mirror upward and off the
strength system. Set the Mirror aside in a secure place;
be careful to avoid scratching or damaging the
Mirror.
59
See the drawing below. Locate a Pulley Carriage
(46). Remove the M8 Jam Nut (106), the M8 x 33mm
Bolt (112), and the Small Pulley (55) from the upper
hole in the Pulley Carriage.
2
Reattach the Small Pulley (55) to the other hole in the
Pulley Carriage (46). Make sure that the Rope (105)
and the Small Pulley move smoothly.
Locate the other Pulley Carriage (not shown) and
repeat these actions.
Then, reattach the parts that you removed, and plug in
the power adapter.
19
105
112
46
106
55