Table of Contents
Advertisement
MAINTENANCE AND TROUBLESHOOTING
MAINTENANCE
Inspect and tighten all parts of the rower regularly.
Replace any worn parts immediately.
To clean the rower, use a damp cloth and a small
amount of mild detergent. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
For best results, clean the rail, the seat carriage, and
the carriage rollers daily.
CONSOLE TROUBLESHOOTING
Most console problems are the result of low batteries;
for replacement instructions, see assembly step 8 on
page 9.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed switch, you must remove the
resistance handle and the right and left shields as
described below.
See the EXPLODED DRAWING on page 23.
Remove the six M4 x 10mm Screws (70) and then
gently remove the Resistance Handle (9).
Next, remove the four M4 x 19mm Screws (69) and the
ten M4 x 16mm Screws (68) from the Right and Left
Shields (7, 8). Then, gently remove the Right and Left
Shields.
Locate the Reed Switch (47). Turn the Left Fan (4) until
a Magnet (85) is aligned with the Reed Switch. Loosen,
but do not remove, the two indicated M4 x 19mm
Screws (69). Slide the Reed Switch slightly closer to or
away from the Magnet, and then retighten the Screws.
47
85
69
Turn the Left Fan (4) so that the Magnet (85) passes
the Reed Switch (47) repeatedly. Repeat these actions
until the console displays correct feedback.
When the reed switch is correctly adjusted, reattach
the parts that you removed.
18
4
Advertisement
Table of Contents
