Mixer Settings (Mixer Setup); Input Page; Monitor Mixer Page - Tascam HS-4000 Owner's Manual

10 – Internal settings

Mixer settings (MIXER SETUP)

Make mixer settings on this screen.
The M I X E R S E T U P screen has 3 pages:
M I X E R and S E T U P .
Touch the tabs at the bottom of the screen to open the
corresponding page.

INPUT page

Make input settings on this page.
INPUT SOURCE
Set the input source for each channel. Select an analog input
(AnalogX) or digital input (DigitalX). ("X" is the channel.) Analog
and digital cannot be selected at the same time.
Analog 1–4 buttons (default):
Analog Inputs 1–4
Digital 1L, 1R, 2L, 2R buttons:
Left and right channels for digital inputs 1 and 2
Fs CONVERT
Turn the sampling rate converter ON or OFF (default) for each
pair of inputs. Channels 1–2 and 3–4 must be set in pairs, so
different settings cannot be used for the channels in each pair
(1–2 and 3–4).
MONITOR PAN
Use these to adjust the stereo position used for monitoring each
channel. Touch a knob, making its background yellow, and use
the DATA dial to set its stereo position.
Range: L 1 0 0 – C – R 1 0 0
Default: L 1 0 0 for CH1 and CH3 and

MONITOR MIXER page

Make monitoring mixer settings on this page. This page differs in
single player and dual player modes.
Single player mode
Dual player mode
78
TASCAM HS-4000
I N P U T , M O N I T O R
R 1 0 0 for CH2 and CH4
METER buttons
Use these buttons to set whether the meter shows the position
before or after the online fader.
Touch the button on the left to show the level before the fader
or touch the button on the right to show the level after the fader
on the meter.
Post/Pre Fader buttons
Use these buttons to set whether the monitoring output is from
before or after the online fader.
Pre Fader button:
Signals from before the online fader are output for
monitoring.
Post Fader button (default):
Signals from after the online fader are output for
monitoring.
Pan knobs
Use these to adjust the stereo position used for monitoring each
channel. Touch a knob, making its background yellow, and use
the DATA dial to set its stereo position.
Range: – –
L 1 0 0 C R 1 0 0
Default: L 1 0 0 for CH1 and CH3 and
Level knob
Use this to adjust the level of the monitoring output. Touch this
knob, making its background yellow, and use the DATA dial to
adjust the level.
Range (dB): –∞ to +10 (default: 0)
NOTE
If the monitoring mixer overload indicator appears on the Home Screen, use
the level knob to lower the level.
Monitoring mixer overload indicators
If the left or right monitoring mixer channel overloads, the
background of the corresponding L or R becomes red.
R 1 0 0 for CH2 and CH4