Redoing An Edit (Redo); Bouncing; Saving A Session - Tascam HS-4000 Owner's Manual

7 – Timeline mode

Redoing an edit (REDO)

After undoing an edit, you can redo it.
1. Touch the E D I T button, and touch the
the pull-up menu.
After redoing an edit, a pop-up window appears showing
completion and the Home Screen reopens.
The E D I T pull-up window will still be open.
NOTE
 If no edit has been undone, the
button appears with white letters when it is possible to redo an edit.
 Only the last undone edit can be redone. Redoing multiple undo
operations is not possible.

Bouncing

You can output part of a region or an interval that crosses
multiple regions as a single take.
Designating the bounce starting point
1. Press the HOME key to open the Home Screen.
2. Use the m and , keys, for example, to locate the
bounce start point (time).
3. Touch the
B o u n c e I / O
menu with buttons related to bouncing.
4. Touch the
S E T I N button on the pull-up menu to set
the bounce starting point (IN point).
The IN mark ( ) appears at the current position in the mark
display area.
Designating the bounce ending point
5. Use the m and , keys, for example, to locate the
bounce ending position (time).
6. Touch the
B o u n c e I / O button to open a pull-up with
buttons related to bouncing.
7. Touch the
S E T O U T button on the pull-up menu to set
the bounce ending point (OUT point).
The OUT mark ( ) appears at the current position in the
mark display area.
Bouncing the interval
8. Touch the
B o u n c e I / O button to open a pull-up with
buttons related to bouncing.
9. Touch the
B O U N C E button on the pull-up menu to
open the B O U N C E N A M E
the bounce file name.
48
TASCAM HS-4000
R E D O button in
button is disabled. The
R E D O R E D O
button to open a pull-up
screen where you can input
Input the file name. Follow the procedures in "Editing the
project name" on page 35.
10. Touch the
E n t e r button on the
11. When a confirmation message pop-up appears, touch
the button or press the DATA dial.
O K
While the file is being created, a progress status pop-up
appears.
When file creation completes, the pop-up disappears.
NOTE
You can cancel a bounce by pressing the
pop-up window is open.
Clearing the bounce starting and ending points
12. Touch the
B o u n c e I / O button to open a pull-up with
buttons related to bouncing.
13. Touch the
C L E A R button on the pull-up menu to
discard the currently set IN and OUT points.
14. When a confirmation message pop-up appears, touch
the O K button or press the DATA dial. The IN ( ) and
OUT ( ) marks in the mark display area will
disappear.

Saving a session

If you do not save a session after editing it, including adding or
changing marks, all changes will be cleared when you load
another session, remove a CF card or turn off the unit's power,
for example.
NOTE
After regions have been edited or marks have been added or edited in a
session, an "*" appears in the session name icon.
1. Press the HOME key to open the Home Screen.
2. Touch the session name button on the Home Screen, and
then touch the S A V E button in the pull-down menu to
save the session.
After saving completes, the Home Screen reopens.
B O U N C E N A M E screen.
C A N C E L button while the progress