Undoing The Previous Edit (Undo); Redoing An Edit (Redo) - Tascam HS-4000 Owner's Manual

7 – Timeline mode

Undoing the previous edit (UNDO)

You can undo the immediately previous timeline editing
operation.
1. Press the HOME key on the front panel to open the Home
Screen.
2. Touch the EDIT MODE button to enter edit mode.
3. Touch the EDIT button to open a pull-up menu.
4. Touch the UNDO button in the pull-up menu to undo the
previous operation. When the undo completes, the Home
Screen will be shown again after a pop-up message appears.
At this time, the EDIT pull-up menu will still be open.
NOTE
• You can also undo using the UNDO button in the Fade/Level
pull-up menu.
• If no editing has been conducted, the UNDO button is
disabled. The UNDO button appears with white letters when
it is possible to undo an edit.
• In timeline mode, a maximum of 10 recording/editing
operations are remembered in the editing history. You can
use the UNDO and REDO functions on operations retained
in this history. However, as the number of edits and regions
increases, the number of operations that can be remem-
bered could become less than 10.
• The editing history in timeline mode will be cleared when
any of the following occur.
• The main unit power is turned off.
• A project/session is loaded.
• AES31 editing information is imported
• The operation mode is changed.
66
TASCAM HS-4000

Redoing an edit (REDO)

After undoing an edit, you can redo it.
1. Press the HOME key on the front panel to open the Home
Screen.
2. Touch the EDIT MODE button to enter edit mode.
3. Touch the EDIT button to open a pull-up menu.
4. Touch the REDO button in the pull-up menu to redo the
previous undo. When the operation completes, the Home
Screen will be shown again after a pop-up message appears.
At this time, the EDIT pull-up menu will still be open.
NOTE
• You can also redo using the REDO button in the Fade/Level
pull-up menu
• If no edit has been undone, the REDO button is disabled. The
REDO button appears with white letters when it is possible
to redo an edit.
• In timeline mode, a maximum of 10 recording/editing
operations are remembered in the editing history. You can
use the UNDO and REDO functions on operations retained
in this history. However, as the number of edits and regions
increases, the number of operations that can be remem-
bered could become less than 10.
• The editing history in timeline mode will be cleared when
any of the following occur.
• The main unit power is turned off.
• A project/session is loaded.
• AES31 editing information is imported
• The operation mode is changed.