Zephir ZFL5130S Manual page 14

21. Remove the packing and make sure that the appliance is intact.. In case of doubt do
not use it and address to an after-sale service reccomanded by the manufacturer.
Children shall not play with the appliance.
22. Cleaning and user maintenance shall not be made by children unless they are older
than 8 and supervised. Keep the appliance and its cord out of reach of children less
than 8 years.
23. After removing the packing materials, check the integrity of the appliance; If you are
unsure, do not use it and ask for qualified professional help.
24. The packing materials (plastic bags, polystyrene foam, nails, etc.) must be kept out
the reach of children because they are potential sources of danger.
25. Before connecting the appliance, check if the electrical voltage and frequency of the
circuit correspond to those indicated on the appliance.
26. This appliance must only be used for the purpose for which it has been
manufactured, therefore as a fan. The manufacturer is not responsible for any
damage caused by improper or incorrect use.
27. WARNING: the installation of this appliance can be done by qualified electricians
ONLY.
28. Since the installation of the equipment sets, the power of the network must be done
through flexible cable plug or by-pole switch with contact opening distance of not less
than 3 mm.
29. Do not make modifications of any kind to this appliance.
30. Do not expose this appliance to the weather (rain, sun, etc.)
31. This appliance is for HOUSEHOLD USE ONLY.
32. Install the appliance at an adequate distance from walls and other objects,etc.
33. Do not expose the appliance to atmospheric agents such as rain, wind, snow, hail.
Do not use outdoors.
34. Regularly inspect the appliance for visible defects. If any faults are found, Do not use
the appliance but contact the Authorized Service Center.
35. If the appliance does not function correctly or there is a fault, contact authorized
Service Center
36. In case the product fall down or it is damaged, or doesn't work as expected.contact
the Authorized Service Center
37. Ensure that the electrical system to which the appliance is connected conforms to
applicable standards.
38. Switch off the power before connecting or repairing the fan.
39. The electrical power supply/socket to which the appliance is to beconnected must be
able to provide the maximum electrical power required by the appliance. If it cannot
do so, arrange for a professionally qualified electrician to make the necessary
modifications.
40. Use a multi-polar switch with minimum contact distance of 3 mm to install the
appliance.
41. Switch off the appliance at the installation's main switch:
-If the appliance does not function
-Before cleaning the outside of the appliance
-If the appliance is not going to be used.