Table of Contents
Advertisement
Installation and disassembly
4.8 Mounting on a pedestal
3. Using a screwdriver, pull down the catch on the rear of the device.
4. Push the device out of the mounting frame.
4.8
Mounting on a pedestal
Installation
1. Place the third housing guide of the device on the top edge of the pedestal
2. Press the device down against the pedestal until the spring catch locks in place
3. Connect the power supply, refer to the section "Power supply (Page 32)".
4. Connect the device to the local network, refer to the section "Properties and functions
(Page 11)".
5. Connect the terminal via as short a cable as possible ≤ 150 mm and a large cross-sectional
area of 1.5 mm² to the functional ground of the system, see section "Grounding (Page 33)
".
26
Operating Instructions, 06/2022, C79000-G8976-C447-03
①
.
②
.
SCALANCE TAP
Advertisement
Table of Contents
