Replacement Parts - Thermo Scientific Lab-Line 100 Operation And Repair Manual And Parts List

NOTE: MAKE NO ATTEMPT TO SERVICE OR REPAIR A LAB-LINE PRODUCT UNDER
WARRANTY BEFORE CONSULTING YOUR LAB-LINE DEALER. AFTER THE WARRANTY
PERIOD, SUCH CONSULTATION IS STILL ADVISED, ESPECIALLY WHEN THE REPAIR
MAY BE TECHNICALLY SOPHISTICATED OR DIFFICULT.
IF ASSISTANCE IS NEEDED BEYOND WHAT THE DISTRIBUTOR CAN PROVIDE, PLEASE
CALL THE LAB-LINE CUSTOMER RELATIONS DEPARTMENT AT (319) 556-2241 OR
(800) 522-5463. NO MERCHANDISE, HOWEVER, SHOULD BE RETURNED DIRECTLY TO
LAB-LINE WITHOUT PRIOR APPROVAL FROM LAB-LINE.
CAUTION: DISCONNECT PLUG FROM ELECTRICAL OUTLET BEFORE
ATTEMPTING ANY MAINTENANCE OR REPAIR OF THIS UNIT.
ROUTINE CLEANING:
Clean up any spills immediately. Remove the plug from its outlet for a
thorough cleaning between incubation periods. The chamber interior and shelves
can be cleaned with a mild detergent or soap and water. Do not use abrasives or
metallic scouring pads on any part of the unit.
To clean the viewing door use a soft damp cloth. A regular window
cleaning solution can be used. Avoid scratching the acrylic plastic.
REPAIRS AND SERVICING:
Unplug the unit from its outlet before servicing. The thermostat is easily
accessible inside the chamber.
A heater is located under the floor of the chamber. Turn the incubator
upside down and remove 4 screws from the bottom of the cabinet. Lift out the
bottom and the insulation covering the heater. Disconnect the heater leads and
remove 2 nuts that hold the heater to the floor of the chamber.
Temperature Control Knob:

REPLACEMENT PARTS

DESCRIPTION PART NUMBER
560-230-00
SECTION 7
10