Saving The Configuration Settings; Saving The Current Configuration - AGFA Drystar 5500 Reference Manual

Drystar 5500, Drystar 5503 | Advanced Operation (key-operator mode) | 51

Saving the configuration settings

Each time the settings have been changed and confirmed, an automatic
backup of the new configuration is made on the hard disk. You will also be
asked to create a back-up floppy.
It is also possible (and recommended) to regularly make a back-up of the
printer settings to ensure safe restoring of the values when required.

Saving the current configuration

1. Press the Key-operator key to enter the Key-operator mode.
2. On the Key-operator main menu, press the Down key four times, followed
by the Confirm key to select 'Save configuration'.
The following screen appears:
When 100% is reached, the following the 'Save configuration' screen is
displayed:
3. Insert an empty floppy disk.
The drive is located at the rear of the printer.
Note: Newer versions of the printer have a Compact flash card
(CF-card) reader instead of a floppy disk drive. This manual
describes how to use a floppy disk. The usage of a CF-card is
analogous.
2900J EN 20180320 1448