AGFA Drystar 5500 Reference Manual page 41

Drystar 5500, Drystar 5503 | Advanced Operation (key-operator mode) | 41
Enter the calibration frequency by means of the Up/Down arrow keys.
5. Press the Confirm key to store the data, or the Escape key to quit the
procedure without any changes.
Related Links
Accessing the Change settings menu
Data entry on page 11
Changing general image quality settings - Default densitometer
1. On the 'Change setting' screen, press the Down key four times, followed by
the Confirm key to select 'Image quality'.
The following screen will appear:
2. Press the Confirm key to select 'General'.
The 'General settings' screen will appear:
3. Press the Down key once, followed by the Confirm key to select 'Default
densitometer'.
The 'Default densitometer' screen is displayed:
Note:
1 pack = 100 sheets
E.g., if the frequency is set to 5, this means that a film
calibration is executed automatically every 5 packs or every
500 sheets.
Note: You can specify to perform an automatic film
calibration after loading every "n" film packs.
on page 23
2900J EN 20180320 1448