Polaris SLINGSHOT S 2019 Owner's Manual page 96

MAINTENANCE
6. Elevate the vehicle until the wheel is slightly off the ground.
7. Remove the wheel nuts and remove the wheel.
WHEEL INSTALLATION
1. With the transmission in gear and the park brake set, place the wheel on the
wheel hub. Be sure the valve stem is toward the outside and rotation arrows
on the tire point toward forward rotation.
2. Install the wheel nuts and finger-tighten them.
On vehicles with tapered rear wheel nuts, make sure the tapered end of the nut
3. Tighten all wheel nuts in a star pattern to specification.
4. Lower the vehicle and remove the floor jack.
SPARK PLUGS
SPARK PLUG RECOMMENDATIONS
Refer to the specifications section beginning on page 121 for the recommended
spark plug type and gap for your vehicle. Torque spark plugs to specification
after installing.
Using non-recommended spark plugs can result in serious engine damage.
Spark Plug Type
Spark Plug Torque
Inspect and replace spark plugs at the intervals recommended in the Periodic
Maintenance Chart beginning on page 67. Inspect spark plugs when the engine
is warm. Always replace spark plugs in sets of four.
94
Downloaded from ManualsNet.com
NOTE
goes into the taper on the wheel.
TORQUE
75 ft-lbs (102 Nm)
NOTICE
Always use the recommended spark plugs.
SPARK PLUG SPECIFICATIONS
search engine
AC Delco 41-103 or equivalent
15 ft-lbs (20 Nm)