Polaris SLINGSHOT S 2019 Owner's Manual page 78

MAINTENANCE
ANGLE DRIVE FLUID
This fluid level does not require routine inspection. If you suspect a fluid leak,
inspect the fluid level.
Always change the angle drive fluid at the intervals outlined in the Periodic
Maintenance Chart section. Always use SLINGSHOT Angle Drive Fluid or
another Fully Synthetic 75W-140 fluid for the angle drive. See the
Recommended Service Products chapter for the part numbers of recommended
service products.
The fill plug is located on the left side of the angle drive housing. The drain plug
is located on the right side of the housing.
FLUID LEVEL CHECK
1. Elevate the vehicle using appropriate jack stands. Make sure the elevated
vehicle is level.
2. Remove the fill plug
hole, add the recommended fluid to bring the level to the bottom edge of the
fill hole.
Use a syringe to add the fluid. If a syringe is not available, remove the battery
76
Downloaded from ManualsNet.com
q
. If the fluid level is not at the bottom edge of the fill
NOTICE
and use a funnel and tube to add the fluid.
search engine