Polaris SLINGSHOT S 2019 Owner's Manual page 92

MAINTENANCE
BRAKE SYSTEM INSPECTION
1. Inspect all brake hoses and connections for dampness or stains from leaking
or dried fluid. Tighten any leaking connections and replace components as
necessary. See the SLINGSHOT Service Manual or your authorized dealer.
2. Check the brake pedal for excessive travel or a spongy feel.
3. Check the brake pads for wear, damage and looseness.
4. Inspect brake discs for nicks, scratches, cracks or other damage. Clean any
grease using an approved brake cleaner or alcohol.
Do not apply WD-40 or any petroleum product to brake discs. These types of
products are flammable and may also reduce the friction between the brake
5. Inspect the brake disc spline and pad wear surface for excessive wear.
Change pads when worn to 3/64" (1 mm).
6. Inspect the thickness of each brake disc at four or more locations around the
disc. If any disc is worn to the minimum thickness at the thinnest point, or if a
disc is damaged, see your dealer for replacement.
BRAKE SYSTEM INSPECTION (SLR ONLY)
1. Inspect all brake hoses and connections for dampness or stains from leaking
or dried fluid. Tighten any leaking connections and replace components as
necessary. See the SLINGSHOT Service Manual or your authorized dealer.
2. Check the brake pedal for excessive travel or a spongy feel.
90
Downloaded from ManualsNet.com
WARNING
pad and caliper.
search engine
Minimum Thickness
Front: 4.5 mm / Rear: 6.5 mm