Polaris SLINGSHOT S 2019 Owner's Manual page 50

PRE-RIDE INSPECTIONS
Turn the ignition key to the ON position before performing the electrical pre-ride
inspections. Return the ignition key to the OFF position after completing these
inspections. If inspection of any electrical item reveals component failure, repair
or replace the component before operating the vehicle.
ITEM
Front Lights
Rear Lights
Turn Signals
Emergency
Flashers
Horn
Low Oil
Pressure
Indicator
Steering
Engine Oil
Level
Fuel Level
Coolant Level
Tires
Wheels
Brake Fluid
Level
Park Brake
Brake System Inspect brake system hoses, connections and brake pads.
48
Downloaded from ManualsNet.com
INSPECTION PROCEDURE
Turn the ignition key on. Verify that the headlights, auxiliary
lights (if equipped) and park lamps illuminate. Switch to high
beam. Verify that the high beam indicator comes on and that
headlamp brightness increases. Adjust headlight aim as
needed.
Verify that the taillights and license plate light illuminate. Apply
the brakes and verify that the taillight lamps increase in
brightness.
Verify that the left and right turn signals flash at the front and
rear of the vehicle, and that the corresponding indicator lamp
flashes in the gauge.
Press the top of the hazard switch to turn the flashers on.
Verify that all four turn signals flash, as well as the lamps in the
gauge. Press the bottom of the switch to turn the flashers off.
Verify that all signals and indicator lamps stop flashing.
Press the horn button. Verify that the horn sounds loudly.
Start the engine and verify that the low oil pressure lamp does
not illuminate.
Check power steering for smooth operation.
Check the oil level.
View the fuel gauge to check the fuel level.
Check the recovery bottle coolant level.
Inspect tire condition, pressure and tread depth.
Inspect for loose, damaged or missing wheel nuts.
Check the master cylinder brake fluid level.
Verify that the vehicle does not roll when the park brake is set.
Check brake pedal for excessive travel or a spongy feel.
search engine
Electrical
General
SEE
PAGE
page
104
-
-
-
-
-
page
49
page
69
page
49
page
79
page
92
page
93
page
89
page
35
page
90