Polaris SLINGSHOT S 2019 Owner's Manual page 64

OPERATION
CRUISE CONTROL TIPS
• Cruise control can be set in any gear.
• Vehicle speed must be above 25 MPH (40 km/h).
• Set speed will vary slightly in hilly terrain.
• The cruise control will not resume a pre-set speed if the resulting acceleration
or deceleration rate is too high or too low. For example, resuming a set speed
from 30 MPH (48 km/h) while in 5th gear may cause cruise to disengage.
• Cruise control will not engage if brake lights are not operating properly.
• Cruise control will be disabled if there is an active stability or traction control
event.
• Cruise control will be disabled if there are multiple wheel speed sensor faults
or a communication error with the electronic stability module.
SET SPEED
1. Move the cruise control ON/OFF/RES switch
control.
POSITION
Left
Center
Right
2. Accelerate to the desired speed. Press and release the SET switch
tip of the lever.
62
Downloaded from ManualsNet.com
FUNCTION
Reset (+)
On
Off
search engine
q
to ON to activate the cruise
w
at the