异常报警/异常指示 Abnormality Alarms/Abnormality Indications - Galanz XQG90-T514VE Service Manual

and stop executing the program.
◆在各阶段测试时剩余时间窗口显示"C01～C08"。
◆The remaining time window displays " C01～C08" in each phase of the test.
◆在自动检测模式执行过程中：任何按键及旋钮均不响应，拔电源退出模式。
◆In the process of automatic detection mode: any key and knob do not respond, pull the power to
exit the mode.
◆在检测模式中：
⇒以上测试旋钮位置可任意旋动，对应测试立即有效；
◆In the test mode:
The above test knob position can be rotated freely, and the corresponding test is effective
⇒每次测试前均需闭合门锁，否则门锁故障报警；
immediately;
⇒各测试阶段均可回旋进行；
Close the door lock before each test, otherwise the door lock will give an alarm;
⇒在此模式下，若旋钮不在以上测试位置，则无任何响应。
All testing stages can be carried out;
In this mode, if the knob is not in the above test position, there is no response.
◆拔电源退出此模式。
◆Unplug the power and exit this mode.
7.异常报警/异常指示 Abnormality Alarms/Abnormality Indications
注：请先仔细检查故障原因再更换元器件。
Note: Please check the cause of the failure carefully before replacing the components.
报警
故障描述
代码
Alarm Fault
code description
进水超时
The water of
E01
machine fills
overtime
故障条件
Fault conditions
1、设定时间内没 1、水龙头未
有到达设定水位 打开或水流
报警； 太慢
1. Alarm when 1. The water
可能故
处理方法
障原因
Possible
Processing
cause of
method
failure
1、检查水龙头是
否开启及水流大
小
1.Open the water
XYJGT90100TVE-001
复位
机器状态
方式
Machine Reset
status mode
启动
暂停 暂停
键复
Pause
位
21