Error Codes And Remedies - Omron V530-R150 Operation Manual

Error Codes and Remedies

Signals cannot be output externally.
RS-232C Communications Errors
No communications are possible.
The Unit operates well initially, but after a while there is no response from
the V530-R150.
9-2 Error Codes and Remedies
9-2-1 QR Code Reading
Error Code
E000 No finder patterns
detected
E001 Finder pattern detection
error (Two patterns were
not detected.)
E002 Finder pattern detection
error (One pattern was
not detected.)
The trigger signal has not been input.
The cables are not correctly wired.
The signal line is disconnected.
The V530-R150 is not in RUN mode.
The cables are not correctly wired.
The communications specifications do not match those of the
external device.
The communications mode was not selected under SYS/
Communications/RS-232C .
The V530-R150 is not RUN mode.
The reception buffer on the external device (e.g. computer) is
full. Check that settings allow the data to be properly received.
Description Remedy
No finder patterns were detected.
Make sure that the image is displayed on the
screen correctly.
Check the printing of the reading code. Three
finder patterns in a corner may be stained or
damaged.
Only one finder pattern was detected.(The
other two patterns were not detected.)
Check the printing of the reading code. Two
finder patterns may be stained or damaged.
The position of finder patterns can be
confirmed on the video monitor when
Display Settings/Finder Pattern is turned
ON.
Only two finder patterns were detected. (One
pattern was not detected.)
One finder pattern may be stained or
damaged.
The position of finder patterns can be
confirmed on the video monitor when
Display Settings/Finder Pattern is turned
ON.
Section 9-2
173