Safety Information; Hazard Location Information/Approvals - Fluke 700G Series Calibration Manual

700G Series
Calibration Manual

Safety Information

A Warning identifies conditions and procedures that are dangerous to the user. A
Caution identifies conditions and procedures that can cause damage to the Product or
the equipment under test.
To prevent possible electrical shock, fire, or personal injury:
•
•
•
•
•
•
•
To prevent possible damage to Product or to equipment under
test:
•
•

Hazard Location Information/Approvals

Ex-Hazardous Areas
An Ex-hazardous area as used in this manual refers to an area made hazardous by the
potential presence of flammable or explosive vapors. These areas are also referred to as
hazardous locations, see NFPA 70 Article 500.
2
Only assemble and operate high-pressure systems if you
know the correct safety procedures. High-pressure liquids
and gases are hazardous and the energy from them can be
released without warning.
Use the Product only as specified, or the protection supplied by
the Product can be compromised.
The battery door must be closed and locked before you operate
the Product.
Replace the batteries when the low battery indicator () shows to
prevent incorrect measurements.
Do not use the Product if it is damaged.
Disable the Product if it is damaged.
Read all safety information before you use the Product.
If the display reads "OL" the range limit is exceeded and the
pressure source must immediately be removed.
Do not exceed the maximum torque allowed. Maximum torque
allowed is 13,5 Nm = 10 ft lb.

® LR110460
Class I, Div. 2, Groups A-D

II 3 G Ex nA IIB T6
KEMA 06ATEX0014 X
Ta=–10 °C... +55 °C
Warning
Caution