Galanz XQG60-U108E After-Sales Service Manual page 38

3
1
2
1
2.用十字批拆除左图
中螺钉 1、2、3、4
4
Use a cross
screwdriver to exit
the screws 1, 2, 3
and 4
3.将面板组件向外翻
转约 90 度
Turn the panel
assembly outward
about 90 degrees
4、用剪钳剪去图中
所示两段扎带 1、2
Use diagonal
cutters to cut out
two sections of tie 1
and 2 as shown in
the figure
5、拔出电脑板上的
2
所有接线端子并整
理线束
Pull out all terminals
on the PCB,
arrange wiring
harness
6、取出面板组件后
做好防静电和防刮
花保护
After removing the
panel components,
make anti-static and
anti-scratch
protection
XYJGT6070UDE-002
使用工具
Using tools
十字批
Cross
screwdriver
1、 使用剪钳时注意不
要剪断线组
When using the
diagonal cutters, be
careful not to cut the
thread
2、 注意拔出接线端子
时请戴防静电手套
Please wear
antistatic gloves
when pulling out the
terminal
3、 装机时需另外补充
两条扎带
Two additional ties
should be added
during installation
使用工具
Using tools
剪钳 防静电手套
Diagonal Antistatic
cutters gloves
37