Enabling The Hourly Time Signal; Turning Off An Alarm Or The Hourly Time Signal - Casio 5686 Operation Manual

3.
Hold down (B) for at least two seconds.
Release the button when the hour setting
starts to flash.
This is the setting mode. The hands
●
automatically shift out of the way for
easy viewing of the display and other
indicators.
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Alarm hour
4.
Use (A) and (D) to change the hour setting.
Holding down (A) or (D) scrolls through
●
settings at high speed.
If you are using 12-hour timekeeping,
●
[P] indicates p.m.
5.
Press (C).
This causes the minutes digits to flash.
Alarm minute
6.
Use (A) and (D) to set the minute setting.
7.
Press (B) to complete the setting
operation.
To stop the alarm
●
Pressing any button while the beeper is
sounding stops it.
Note
A beeper sounds for 10 seconds when
●
an alarm time is reached.
The watch will automatically return
●
from the Alarm Mode to the
Timekeeping Mode if you do not
perform any operation for about two or
three minutes.
Watch Operation Guide 5686
Enabling the Hourly Time
Signal
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Press (D) to display the hourly time signal
screen ([SIG]).
3.
Press (B) to toggle the hourly time signal
between enabled (on) and disabled (off).
[SIG] is displayed while the hourly time
●
signal is enabled.
Turning Off an Alarm or the
Hourly Time Signal
To stop an alarm or the hourly time signal from
sounding, perform the steps below to turn it
off.
To have an alarm or hourly time signal
●
sound again, turn it back on.
Note
Indicators are displayed while any of
●
the alarms or the hourly time signal is
turned on.
The applicable indicators are not
●
displayed while all of the alarms are
turned off and/or the hourly time signal
is turned off.
Hourly time signal
Alarm
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Use (D) to scroll through the alarm ([AL1]
to [AL5]) and hourly time signal ([SIG])
screens until the one you want to turn off
is displayed.
Alarm or hourly time signal
3.
Press (B) to turn off the displayed alarm or
the hourly time signal.
Each press of (B) toggles between on
●
and off.
Turning off all of the alarms and the
●
hourly time signal causes [ALM] and
[SIG] to disappear from the display.
Note
If [ALM] remains on the display, it
●
means that at least one alarm is still
turned on. To turn off all of the alarms,
repeat steps 2 and 3 until the [ALM]
indicator is no longer displayed.
18