3.
Hold down (A) for at least two seconds.
Release the button when the hours digits
start to flash.
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Alarm hour
4.
Use (B) and (D) to change the hour setting.
Holding down (B) or (D) scrolls through
●
settings at high speed.
If you are using 12-hour timekeeping,
●
[P] indicates p.m.
5.
Press (C).
This causes the minutes digits to flash.
Alarm minute
6.
Use (B) and (D) to set the minute setting.
7.
Press (A) to exit the setting screen.
(alarm) is shown on the
●
display while an alarm is turned on.
Watch Operation Guide 3541
Testing the alarm
●
In the Alarm Mode, hold down (D) to sound the
alarm.
To stop the alarm
●
Pressing any button while the beeper is
sounding stops it.
Snooze causes the alarm to sound up to seven
times, at five-minute intervals. To cancel a
snooze alarm, turn [SNZ] off.
Turning Off an Alarm or the Hourly Time
l
Signal
Note
A beeper sounds for 10 seconds when
●
an alarm time is reached.
The watch will automatically return
●
from the Alarm Mode to the
Timekeeping Mode if you do not
perform any operation for about two or
three minutes.
Enabling the Hourly Time
Signal
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Use (D) to display the hourly time signal
screen ([SIG]).
3.
Press (A) to toggle the hourly time signal
between enabled and disabled.
(hourly time signal) is shown on
●
the display while the hourly time signal
is turned on.
Turning Off an Alarm or the
Hourly Time Signal
To stop an alarm or the hourly time signal from
sounding, perform the steps below to turn it
off.
To have an alarm or hourly time signal
●
sound again, turn it back on.
Note
Indicators are displayed while any of
●
the alarms or the hourly time signal is
turned on.
The applicable indicators are not
●
displayed while all of the alarms are
turned off and/or the hourly time signal
is turned off.
Alarm
Snooze
Hourly time signal
21