Alarm; Using Casio Watches To Configure Alarm Settings; Configuring Alarm Settings; Enabling The Hourly Time Signal - Casio EDIFICE ECB-S100D-2A Operation Manual

Table of Contents

Advertisement

Alarm

The watch will beep when an alarm time is
reached. You can set up to five different
alarms. The hourly time signal causes the
watch to beep every hour on the hour.
The alarm sound is muted in the cases
described below.
When battery power is low
ー 
When watch is at Level 2 power saving
ー 
Power Saving Function
l
Using CASIO WATCHES to
Configure Alarm Settings
If the watch is paired with a phone, you can
also use CASIO WATCHES to set alarms.
Configuring Watch Settings
l

Configuring Alarm Settings

1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Press (D) to scroll through alarm numbers
([AL1] to [AL5]) until the alarm you want to
configure is displayed.
Alarm time
Alarm number
Watch Operation Guide 5658
3.
Hold down (A) for at least two seconds.
Release the button when the hours digits
start to flash.
This is the setting mode. The hands
automatically shift out of the way for
easy viewing of the display and other
indicators.
4.
Use (B) and (D) to change the hour setting.
If you are using 12-hour timekeeping,
[P] indicates p.m.
5.
Press (C).
This causes the minutes digits to flash.
6.
Use (B) and (D) to set the minute setting.
7.
Press (A) to exit the setting screen.
while an alarm is turned on.
8.
Hold down (C) for at least one second to
return to the Timekeeping Mode.
Alarm hour
Alarm minute
(Alarm) is shown on the display
To stop the alarm
Pressing any button while the beeper is
sounding stops it.
Note
A beeper sounds for 10 seconds when
an alarm time is reached.
The watch will automatically return
from the Alarm Mode to the
Timekeeping Mode if you do not
perform any operation for about two or
three minutes.
Enabling the Hourly Time
Signal
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Use (D) to display the hourly time signal
screen ([SIG]).
3.
Press (A) to toggle the hourly time signal
between enabled and disabled.
(hourly time signal) is shown on the
display while the hourly time signal is
enabled.
4.
Hold down (C) for at least one second to
return to the Timekeeping Mode.
18

Advertisement

Table of Contents
loading

This manual is also suitable for:

Edifice ecb-s100hg-1aEdifice ecb-s100hr-1a

Table of Contents