Table of Contents
Advertisement
Alarm
The watch will beep when the alarm time is
reached. You can configure up to four
standard daily alarms, and one daily alarm
with snooze. The hourly time signal causes the
watch to beep every hour on the hour.
Snooze causes the alarm to sound up to
●
seven times, at five-minute intervals.
Configuring Alarm Settings
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Press (D) to scroll through alarms ([AL1]
to [AL4], [SNZ]) until the one you want to
configure is displayed.
Alarm number
Alarm time
3.
Hold down (A) for at least three seconds.
Release the button when the hour digits
start to flash.
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Alarm hour
Watch Operation Guide 5715
4.
Use (B) and (D) to change the hour setting.
Holding down (B) or (D) scrolls through
●
settings at high speed.
If you are using 12-hour timekeeping,
●
[P] indicates p.m.
5.
Press (C).
This causes the minutes digits to flash.
6.
Use (B) and (D) to set the minute setting.
7.
Press (A) to exit the alarm time setting
screen.
8.
Press (A) to toggle the alarm between on
and off.
To stop the alarm
●
Pressing any button while the beeper is
sounding stops it.
Snooze causes the alarm to sound up to seven
times, at five-minute intervals. To cancel a
snooze alarm, turn [SNZ] off.
Turning Off an Alarm or the Hourly Time
l
Signal
Note
A beeper sounds for 10 seconds when
●
an alarm time is reached.
The watch will automatically return
●
from the Alarm Mode to the
Timekeeping Mode if you do not
perform any operation for about two or
three minutes.
Alarm minute
Enabling the Hourly Time
Signal
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Use (D) to display the hourly time signal
screen ([SIG]).
3.
Press (A) to toggle the hourly time signal
between enabled and disabled.
Turning Off an Alarm or the
Hourly Time Signal
To stop an alarm or the hourly time signal from
sounding, perform the steps below to turn it
off.
To have an alarm or hourly time signal
●
sound again, turn it back on.
Note
Indicators are displayed while any of
●
the alarms or the hourly time signal is
turned on.
The applicable indicators are not
●
displayed while all of the alarms are
turned off and/or the hourly time signal
is turned off.
Snooze
Alarm
Hourly time signal
10
Advertisement
Table of Contents
