Table of Contents
Advertisement
Measuring Lap Times
1.
Enter the Stopwatch Mode.
Navigating Between Modes
l
If a stopwatch timing operation is in
●
progress, press (D) to stop it and then
press (B) to reset the stopwatch to all
zeros before performing the operation
in step 2.
2.
Use the operations below to measure
elapsed time.
Each press of (B) displays, for about
●
eight seconds, the time elapsed (lap
time) since the last lap time operation.
D
Start
B
Lap
D
Stop
Elapsed time is shown in 1/1000-
●
second units for the first hour of the
measurement session. After the first
hour, elapsed time is shown in 1/10-
second units.
The mode hand points to the seconds
●
of the lap time. If more than 120 seconds
have elapsed since timing was started,
the mode hand points to [OVER].
First hour
After first hour
1/1000 seconds
Seconds, 1/10 seconds
Minutes, seconds
Hours, minutes
Lap time seconds
3.
Press (B) to reset the stopwatch to all
zeros.
Watch Operation Guide 5686
Example: Recording a Race
Lap Time
This section explains how to record lap times
while watching a race. It also shows how you
can view lap times with CASIO WATCHES
after the race is over.
Lap Times
l
During a race
Measure lap times.
1.
Enter the Stopwatch Mode.
Navigating Between Modes
l
2.
Use the operations below to perform a
timer operation.
Pressing (B) at the end of each lap will
record them in watch memory.
Lap times are recorded in 1/1000-
●
second units during the first hour of an
elapsed time measurement session.
After one hour, times are recorded in
1/10-second units.
3.
Press (B) to reset the elapsed time to all
zeros.
4.
Hold down (C) for at least two seconds to
return to the Timekeeping Mode.
After a race
You can view the measured lap times with
CASIO WATCHES.
Sending Stopwatch Data to a Phone
l
Checking a Lap Time
l
D
Start
B
B
D
Stop
Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
The beeper will not sound if battery power
●
is low.
Using CASIO WATCHES to
Configure Timer Settings
If the watch is paired with a phone, you can
also use CASIO WATCHES to set the timer
start time.
Configuring Timer Settings
l
Setting the Countdown Start
Time
The countdown start time can be set in 1-
second units up to 24 hours.
If a timer countdown operation is in
●
progress, reset the timer to its current start
time before performing this operation.
Using the Timer
l
1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Hold down (B) for at least two seconds.
Release the button when the hour setting
starts to flash.
This is the setting mode. The hands
●
automatically shift out of the way for
easy viewing of the display and other
indicators.
Hours
20
Advertisement
Table of Contents
