World Time City Setting; Swapping Your Home Time And World Time; Alarm; Using Casio Watches To Configure Alarm Settings - Casio 5686 Operation Manual

World Time City Setting

Use the procedure in this section to select a
World Time city. If you are in an area that
observes summer time, you can also
configure a summer time setting.
Note
The initial factory default summer time
●
setting for all cities is [AUTO]. In many
cases, the [AUTO] setting lets you use
the watch without switching between
summer time and standard time.
1.
Enter the World Time Mode.
Navigating Between Modes
l
2.
Use (D) to display the city you want.
Holding down (D) scrolls through
●
settings at high speed.
3.
To change the summer time setting, hold
down (B) for at least two seconds.
Release the button when [AUTO] starts to
flash.
This is the setting mode. The hands
●
automatically shift out of the way for
easy viewing of the display and other
indicators.
Watch Operation Guide 5686
4.
Use (D) to change the summer time
setting.
Each press of (D) cycles through settings
in the sequence shown below.
[AUTO]
●
The watch switches between standard
time and summer time automatically.
[OFF]
●
The watch always indicates standard
time.
[ON]
●
The watch always indicates summer
time.
5.
Press (B) to complete the setting
operation.
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
While [UTC] is selected as the city, you
●
will not be able to change or check the
summer time setting.
If you select a World Time City with
●
CASIO WATCHES and then change to
a different city with a watch operation,
the CASIO WATCHES city information
is deleted from the watch.
Configuring World Time Settings
l
Swapping Your Home Time
and World Time
In the World Time mode, hold down (A) for at
least two seconds to swap your Home City
time with your World Time.
Before swapping
World Time
Home Time
The watch will beep when an alarm time is
reached. You can set up to five different
alarms. The hourly time signal causes the
watch to beep every hour on the hour.
The beeper will not sound if battery power
●
is low.
Using CASIO WATCHES to
Configure Alarm Settings
If the watch is paired with a phone, you can
also use CASIO WATCHES to set alarms.
Setting the Alarm
l

Configuring Alarm Settings

1.
Enter the Alarm Mode.
l
2.
Press (D) to scroll through alarm numbers
([AL1] to [AL5]) until the alarm you want to
configure is displayed.
After swapping
Home Time
World Time

Alarm

Navigating Between Modes
Alarm time
Alarm number
17